Way back in April, an email was sent by Bob to Francesco Celani requesting some clarifications about the use of acetone and secondly, the potential for ionising radiation to play a role in H2 disassociation and triggering of the condensed matter.
Hi Francesco, Thank you for arranging to share this information with us. We will need to know the procedure and timing for adding the acetone in our protocol and it would help if you can suggest ways to effectively add it into our cells as we should probably make this part of our major experiment we are currently undertaking. Do you have any suggested mechanisms for how Acetone is helping the LENR effect? - Adsorption based catalytic effect? Also do you have any opinions about using Potassium compounds such as Potassium Titanate, Potassium Carbonate, Potassium Hydroxide. I have been thinking that the 40K decay processes, whilst small, might assist in triggering Ni+H LENR. In the HUG concentric calorimeter, we could pack the spare cell capacity with Potassium Titanate powder which has a melting point of 1150 degrees C so it would remain Homogenous allowing both Acetone and H2 access to the wire / nano structures. Do you think this direction of investigation has merit? Regards Bob Greenyer |
Celani replied
Dear Bob, I think that it CAN BE another PARALLEL channel of reaction, due to Carbon * About K_40 effect, it can be usefull/interesting. * Just remember that in our "old" chemical treatments (over Pd and Ni * Anyway, the K_40 has beta- (1311 keV), beta+ and EC (1505 keV) and the * Let me know the results. Francesco |
Then last night, Stoyan Sarg made contact and asked us if we might post the piece below for discussion
The notion of using potassium compounds has been presented to him, however, he replied "From my theoretical point of view the potassium could not be a suitable."
Does anyone out there have any better ideas?
Comments
I bet you can buy it in India.
That could be worth a look. We've also been thinking about a K:Fe2O3 catalyst to throw in with Ni powder.
@ All
Does anyone have the correct paper requirements to purchase deuterium? Or does anyone know someone who could? We are running into issues when looking to purchase small amounts of this gas.
RSS feed for comments to this post