In this video you can see Ryan and Malachi carefully loading Celani wire for the first time. You can really see the whole way the cell is assembled.

In this short Video, Ryan explains the baseline calibration that will help to assess any potential excess heat that may be observed in active loaded wire testing. He is also frank about the challenges. We encourage people to challenge the approach and make suggestions. If you have any doubts let us know - this is for everyone!

As the last calibration runs are carried out on the US cell by the HUG team, Tyler takes a tour round the facility asking questions and getting his hands dirty (well, reading a monitor).

he EU reactor arrived earlier in the week but had to wait until a lab room had been prepared for it before unboxing. In this video you can see the care that was taken to make sure its trip across the pond was successful. This is a trial run for when we are ready to ship second generation reactors around the globe in the event of successful internal Celani replications.

...

...

Celani is asked informal questions by a number of people about his reactor, its construction, operation and design.

...